|
Product Details
 |
MK4 chassis engine pendulum mount |
 |
|
|
The VW factory rear engine mount was designed as a soft mount flexible mount, to provide a very comfortable drive. It's drawback was the large amount of engine movement it allowed under torque load and on hard acceleration. Engine movement of the decreases stability under high performance driving conditions and gear selection.
To reduce this movement VF-Engineering made a complete replacement billet mount fitted with moulded, high durometer polyurethane inserts. The mount is constructed from billet aluminum and supplied with high tensile hardware. Which means the stock mount will snap before the Z-Eng mount even bends. Fitting should take no more than 20 minutes maximum
This high performance mount has been tested on a supercharged MK4 VR6 with 280hp and provides a dramatic difference in the stability of the car when accelerating and braking hard. The effect is far greater than you get by just changing your bush inserts. Made from billet aluminum, under the severest conditions this mount will bend whilst the OE mount will snap. Gear changing under hard acceleration is also greatly enhanced. It makes a terrific difference on the 1.8T giving you much greater control over drifting and wheel spin reduction for dragging
Pendulum Mount Specification:
• Direct replacement part
• Sealed surface "cast look" finish
• Constructed from CNC machined 6061 billet aluminum
Notes :
fits all VAG Type 4 Chassis: Golf/Jetta 4, Beetle, Bora, Audi A3, Audi TT.
|
| Part # |
Description |
Price |
|
| VFMK4CM |
MK4 chassis engine pendulum mount |
$179.00 |
|
|
|
|
